Sudo make installAfter this, your driver should be installed and to ensure proper function, I suggest restarting and leaving the wifi adapter plugged in on reboot so that it is recognized and configured correctly. Sudo apt-get install build-essential build-dep Then you'll have to locate your source code folder, build your driver and install it. First you'll need to make sure you have the dependencies installed before you build. To build the driver from source is not a scary task. After building from source, I restarted and left the card plugged into my laptop, and it was recognized by Kali with full support like an Alfa card. OpenWrt SNAPSHOT r12576-f2d976f06e / LuCI Master git-20.074.84698-03af89a I have already installed: kmod- rt w88 4.19.108+5. Original Realtek RTL8812BU chipset inside, easy installation, high signal stability Up to 1200 Mbps speed, dual band 5.8 GHz (867 Mbps) or 2.4 GHz (300 Mbps) USB 3. I am using the actual snapshot (ATH79) for my GL.iNet GL-AR300M-Lite. The precompiled debian packages never fully installed a gave me a dkms error when adding the module to the kernel headers. This rtl8812bu USB Adapter wont work (lsusb output): Bus 001 Device 002: ID 0bda:b812 Realtek Semiconductor Corp. I clone the repository and built the driver from source. I would strongly suggest you check your chipset and make sure that it is compatible (mine is a BrosTrend AC1200 dual band V2 card) before attempting this. I have found a solution to this issue that works for my AC1200 dual band card, with packet injection support and monitor mode working.
0 Comments
Leave a Reply. |